How much does Ceiling & Partition Services cost in KL & Selangor?
Use this guide to understand fair Klang Valley pricing before requesting a fixed quote. Final cost depends on measurements, access, materials and the actual site condition.
How much does Ceiling & Partition Services cost in KL & Selangor?
Ceiling & Partition Services in KL & Selangor starts from RM 220; the 3 published rates below are priced per job, per sq ft. Every figure is confirmed in writing before work starts, while access, materials and site condition move the final number — run the Ceiling & Partition Services estimator for an instant ballpark, then send photos and measurements for a fixed written quote.
- Published rate book
- Fixed quote in writing
- No hidden fees
Ceiling & Partition Services price list
Every figure in this table is the same published rate our estimators and written quotes use — one rate book, three surfaces, no drift.
| Scope | Our published rate | What's covered |
|---|---|---|
| Water-Damaged Ceiling Repair | From RM 220 | Removing moldy, rotting plasterboard, addressing the leak source, and fitting a clean moisture-resistant panel. |
| Plaster Ceiling Installation | From RM 10 / sq ft | Elegant flat, tiered, or L-box plaster ceiling setups with custom cutout channels for downlights. |
| Gypsum Board Partition Wall | From RM 11 / sq ft | Durable, paint-ready partition walls to divide office rooms, bedrooms, or storage areas. |
Ceiling & Partition Services jobs priced after a site visit
These jobs depend on measurement, access or site conditions we can't judge from a message. Send photos on WhatsApp and we confirm a fixed price before work starts.
Cornice & L-Box Concealed Light Trough
Custom decorative moldings and ambient indirect LED lighting plaster designs.
Typical Ceiling & Partition Services prices in KL & Selangor
Verified baseline ranges, last reviewed 2026-07-25. Your final quote is confirmed after scope and a site visit.
| Scope | Our published rate | Typical local range | Notes |
|---|---|---|---|
| Plaster ceiling repair | From RM 220 | RM 180–RM 1,500+ depending on board and frame damage | Small patch repairs start at standard callout scope; larger replacement is priced by measured area. |
| Plaster ceiling installation | From RM 10 / sq ft | RM 6–RM 15 / sq ft depending on design | Within typical Klang Valley rates for plain gypsum ceiling; L-box and tiered designs cost more. |
How a Ceiling & Partition Services estimate adds up
At typical quantities, 2 × water-Damaged Ceiling Repair at RM 220 = RM 440, before the condition, access and urgency factors above. The calculator below runs the same math for your exact quantities.
What affects Ceiling & Partition Services cost?
We confirm these points before work starts so the quote is clear and approved first.
Where these Ceiling & Partition Services prices come from
What to measure before you call
The fastest way to a fixed price: send photos and these measurements on WhatsApp. We confirm the price before dispatch.
Try the Ceiling & Partition Services calculator
Answer a few questions and get a ballpark price from the same published rates — including labour and standard materials.
Open the Ceiling & Partition Services estimatorNeed an exact Ceiling & Partition Services quote?
Send photos, measurements and your area. We confirm the itemised fixed-price quote before work begins.
WhatsApp for QuoteEmergency Ceiling & Partition Services in KL & Selangor
For urgent problems, send photos, your area, and a short video if safe. We triage the risk, explain immediate steps, and confirm a fixed emergency quote before permanent work begins.
Urgent response guideCeiling & Partition Services cost FAQs
What is the starting price for Ceiling & Partition Services?
Are your prices fair for KL & Selangor?
Can I get a quote from photos?
Do you charge hidden fees?
Why is my plaster ceiling cracking or sagging?
Do you install sound insulation inside the partition walls?
Is plaster ceiling installation clean, or will my house be filled with white dust?
Can you cut holes for my new LED downlights and fans?
The Ceiling & Partition Services job, step by step
These are the steps a confirmed Ceiling & Partition Services quote covers — the price above buys this work, in this order.
- 01
Grid Assembly
We map out alignments with laser levels and install rust-proof Galvanized Steel (GI) runners and hangers.
- 02
Board Installation
High-grade gypsum plasterboards are screwed securely onto the metal framework using rust-resistant drywall screws.
- 03
Joint Taping
We apply heavy-duty fiberglass mesh joint tapes over all board seams to prevent future settlement cracks.
- 04
Double Skim Coat
Two coats of premium joint compound plaster are skimmed across all joins and screws, sanded down to a glass-smooth level.
- 05
Flawless Handover
The ceiling or partition is vacuumed of plaster dust, wiped clean, and primed ready for the topcoat paint colors.
Other services you might need
Browse our other home services across KL & Selangor — fixed pricing and same-day slots available.